DIY Christmas Sweater Sleeve Trees: VMMV Sweater Week Part III

diy sweater sleeve trees

Even evergreens need an extra layer in December. These trees are made from the sleeves of old cable-knit sweaters! My favorite, cozy sweater finally shrank, pilled, and stretched in ways that I could no longer really be seen in public with it…however comfy it still was. It still was so wintery though, I cut off the sleeves, stitched up the seam, and made it into cozy, Christmas sweater-sleeve trees for part III of VMMV sweater week. (check out part I and II as well if you haven’t been following along!)forthetreediy sweater sleeve trees

For the tree, you’ll need construction paper, an old cable-knit sweater, and a needle and thread:

  • Start by forming a cone from heavy construction paper.
  • Then, cut the sleeve off of the sweater and make another cut down the length of the sleeve so you have a sort of blunted triangle shape.

diy sweater sleeve tree

  • Wrap the sleeve around the cone. For one cone, the wrists were wider than the arms so these sleeves went wrist first over the cone with the wrists forming the widest part. For a different sweater, the wrist was tighter so this became the tip of the cone. Play around to see how it best fits the cone and then stitch up the back of the sleeve so it fits tightly.
  • Tuck in the edge of the sleeve into the hole formed by the paper cone at the top. If the sleeve doesn’t form a nice border at the base of the tree, tuck that edge under as well and hot-glue to the inside of your cone.

sweater sleeve tree

Embellish! That’s the fun part, I added little pom-poms and a few stars made with sweater scraps. forthebasediy sweater sleeve tree

You could just leave the cones by themselves, but a little rustic base made it looked so whimsical I had to add it. You will need some short, straight sticks, rubber-bands, and floral foam:

  • Gather twigs (I used grapefruit twigs) and tie them together using a rubber-band. Make sure your twigs are fairly straight and mostly all the same length.
  • Push the tight side of the twigs into a piece of floral foam that just fits into the base of the sweater-sleeve cone. The foam needs to fit tightly so it can support the tree!

diy sweater sleeve tree

Push the twigs and foam into the base of the tree. You’ll have to play around with the twigs a bit to get an even base that will stand up straight but once you get it just right, it’s very steady!diy sweater sleeve treechristmas sweater sleeve treesdiy sweater sleeve treediy christmas sweater treessweater sleeve treediy christmas sweater sleeve trees

 I love this project. It’s so cheap, recycles something you’d otherwise probably throw out, and looks so adorable. Each one looks different depending on the sweater and the embellishments you use, and they’re so simple yet make quite the statement if you make a little grove of them…Baby, it may be cold outside, but even your evergreens can be cozy in their sweater-sleeves…Now go get a sweater a get busy!

– <3 A.